Basic Operation - Teac NT-503 Network Manual

Basic operation

To connect the unit to a network, install the dedicated app (free) on
a smartphone or tablet, connect it to the same network as the unit,
and then conduct the following procedures.
o Make settings using NETWORK SETUP to connect this unit to the
network (page 17)
The following explanations and illustrations show examples when
TEAC HR Remote is installed on an iPod touch.
Launching the app
Tap the TEAC HR Remote app on the home screen.
The app will search for the NT-503 connected to the network
and show the current input source.
Input source
o When the connected device selection screen appears, tap
the connected device.
o If "Searching" continues to appear for several minutes and
the unit cannot be connected, check the network settings
on the unit and the smartphone or tablet that has the app
installed.
o After turning this unit's POWER switch on or when NET
STANDBY is set to "OFF", connection is not possible for about
a minute after startup until initialization completes.
6
Changing the input source
Tap the input source.
When the list of input sources appears, tap an input source to switch
to it.
c