Part Ii - Mic Pre Module; Part Iii - Cabling; Signal Flow - Neve 1073LB EQ User Manual

1073LB EQ
Part II – Mic Pre Module
On the rear of the 1073LB Mic Pre module, there may be a similar pair
of switches.
u Switch 2 (right), should be set to Off for Insert mode.
If you have an older version of the module that does not have this switch
block, please refer to the 1073LB Mic Pre User Manual that tells you how
to put the module into Insert mode.

Part III - Cabling

u Connect the supplied 3-pin cable to the INS LINK connector on the
rear of one of the modules, then secure this module into the Lunchbox
leaving the other end of the cable free.
u Plug the other end of the link cable into the other module and secure
into the Lunchbox in the adjacent slot (the order of modules is not
important).
With the modules fitted, the cable loop is designed to fit in the space
underneath the Lunchbox backplane (right).
The INS LINK cable has part number NN 5749.

Signal Flow

With the 1073LB Mic Pre and 1073LB EQ modules linked in this way:
The Input XLR on the 1073LB EQ is ignored as the source of input
•
into the EQ circuitry, even if there is an XLR connected and
carrying a signal.
The input into the 1073LB EQ circuitry will be taken from the INS
•
LINK cable and therefore from the adjacent 1073LB Mic Pre.
The Output XLR however, will still carry the same Output signal as is
provided to the link cable and into the 1073LB Mic Pre, providing a parallel
output signal post-EQ.
This output will be electronically balanced.
- 7 -
Issue 3.1