Standalone Mode; Xlr Pinouts; 1073Lb Mic Pre Insert Mode; Part I - Eq Module - Neve 1073LB EQ User Manual

1073LB EQ
All 1073LB EQ modules leave the factory configured to work in Standalone
mode.
u Ensure that the Lunchbox power is off, and then insert the module into
the Lunchbox housing.
u Make sure the module backplane mates securely into the Lunchbox
backplane connector, and the faceplate is flush with the front of the
Lunchbox before securing into place.
u Connect the Line-level Input and Output to the XLR connectors on the
rear of the Lunchbox.
In Standalone mode, the audio signals will pass through the
electronically balanced Input and Output of the 1073LB EQ module.
Shown above, the 1073LB EQ switch block set to Standalone mode.
All modules are set to this mode when they leave the factory -
Switch 1 (left) On, switch 2 (right) Off.

XLR Pinouts

Hot 2
Cold 3
Ground 1
This configuration is where the EQ module acts as a true audio insert on
an adjacent 1073LB Mic Pre module.
This involves connecting both of the units together with the supplied
cable, and setting both of the 1073LB EQ and 1073LB Mic Pre modules
to work in Insert mode.
Part I – EQ Module
On the rear of the 1073LB EQ, there are two switches inside the unit,
next to the edge connector (see pic, above).
u When using the module as an Insert with an adjacent 1073LB Mic Pre
module, the 1073LB EQ switches should be set to:
Switch 1 (left)
Switch 2 (right)
Please use a non-metallic plunger for setting these switches.
- 6 -

1073LB Mic Pre Insert Mode

Off
On
Issue 3.1

Standalone Mode