Table of Contents
Advertisement
6 - 1 Upgrading your
computer
Pre-installation instructions
Always observe the following before you install any component:
1. Make sure that the ODD and card reader slot is empty.
2. Turn off the power to the computer and all peripherals.
3. Unplug the power cord from the computer.
4. Unplug the network cable and all connected peripheral devices
from the computer.
5. Place the computer on a flat, steady surface.
6. Open your computer according to the instructions on
the rear system cover on page 7
system cover on page
7. See the following sections for specific instructions on the
component you wish to install.
Warning
Not turning off the computer properly before you start installing the
components may cause serious damage. Do not attempt the
procedures described in the following sections unless you are a
qualified service technician.
Post-installation instructions
Observe the following after installing a computer component:
1. See to it that the components are installed according to the step-
by- step instructions in their respective sections.
2. Replace any expansion boards or peripherals that you removed
earlier.
3. Replace the system covers. See
cover on page 10
page
8.
4. Connect the necessary cables.
5. Turn on your computer.
9.
Installing the left side system
and
Installing the rear system cover on
and
Removing the left side
Removing
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Predator P09-600 and is the answer not in the manual?