Table of Contents
Advertisement
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.5, No. 25)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Analog Surround
Audio Header
(17-pin HD_AUDIO2)
(see p.5, No. 28)
3W Audio AMP Output
Wafer Header
(4-pin SPEAKER1)
(see p.5, No. 27)
GN D
OUT2_L
J_SENSE
PRESENCE#
OUT2_R
MIC_RET
MIC2_R
OUT_RET
1
PIN
2
1
1
Front_L-
Front_L+
Front_R+
Front_R-
This header is for
connecting audio devices
to the front audio panel.
MIC2_L
Signal
PIN
Name
18
SENSE
17
16
LFE
15
14
A_GND
13
12
Surr_Rear_R
11
10
9
A_GND
8
7
Surr_Side_R
6
5
A_GND
4
3
Front_R
2
1
A_GND
Please connect the chassis
speaker to this header.
J3160TM-ITX
Signal
Name
KEY
A_GND
Center
A_GND
Surr_Rear_L
A_GND
Surr_Side_L
A_GND
Front_L
15
Advertisement
Table of Contents
