Warranty; Mounting Your Tv To The Wall - RCA L42WD22 User Manual

Problems with V-Chip/Parental Controls
The rating limits don't work
• You must lock the settings. Go to the Main Menu (press MENU on your remote), select Parental control, select Lock
Parental Controls.
I don't remember my password and I want to unlock the TV
If you forget your password, turn the TV off. Simultaneously press and hold VOL v on the side panel and CLEAR on
•
the remote for 10 seconds. Next time you enter the Parental control menu enter a new password
The V-Chip won't let me watch a program even though it's not rated as violent.
• Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set NR to View
separately in order to view movies with an NR rating.
What Else Can I Do?
If you've been through the Troubleshooting section and nothing has fi xed your problem, try rebooting your TV. Note
that after a reboot you may need to run your TV through the setup process again. To do a reboot, unplug the power
cord from the wall outlet, power strip, etc. Keep your TV unplugged for about 5 minutes. Then plug the TV back in,
turn on the TV, and see if the problem is fi xed. If the problem remains, then please visit www.rca.com/television for
updated FAQs or contact RCA Customer Support at the support number provided in your Warranty under How To Get
Service.
Bottom of the base
Remove the screws from the four holes on
each side of the bottom of the TV's base.
Chapter 5
Other Information

Mounting Your TV to the Wall

Caution: The wall mount must bear a minimum of fi ve times
the TV's net weight without causing damage.
To mount your TV to the wall you need to purchase a VESA wall
mount. For models L37WD22 and L42WD22, purchase a VESA 400 x
400, M6 x 10mm; and model L46WD22 purchase a VESA 600 x 400, M6
x 10mm (400 x 400, for example, means the mounting measurements
are 400mm horizontally and 400mm vertically; M6 x 10mm is the type
screw that needs to be used).
1. You need to remove the base fi rst before attaching the wall mount.
A. Place the TV facedown on a surface that is soft, yet strong
enough to hold the TV.
B. Use a screwdriver to remove the screws from the four holes on
each side of the bottom of the TV's base as the arrows indicate
to the left.
2. Make sure all cables are already connected to the TV.
3. Follow the directions included with the wall mount to mount the
TV to the wall.
43