Advertisement
Advertisement
Table of Contents
Summary of Contents for AAB ABM-200
- Page 1 ABM-200 Airflow & Environmental Meter User Guide...
-
Page 2: Table Of Contents
Introduction to the ABM-200 Table of Contents (by page number) Overview First connection Settings LED Indicators General Use Sending and Editing Reports Maintenance (Change Battery/Cleaning/Storing) 10 Troubleshooting 11 Technical Data 11 Range & Accuracy 12 Glossary... -
Page 3: Overview
Overview Airspeed Temp/Humidity Sensor Power Button ¼-20 Threaded Port Battery Door... -
Page 4: First Connection
None of the items granted for access is used for any purpose other than your use of the meter. AAB does not gain access to, receive or retrieve any of your personal data or information. - Page 5 This will bring you to the start screen. On the ABM-200, press the power button marked with the AAB logo. The app screen will change to show the device is connected and ready to take readings.
-
Page 6: Settings
The LED will flash when the button is pressed until connection. Once connected, the LED will stop flashing. The phone will inform the user of the connection to the ABM- 200. When shutting off the ABM-200 with the power button, the LED will fast flash for 1 second to indicate shutdown. General Use... -
Page 7: Sending And Editing Reports
Sending and Editing Reports Reports can be accessed and sent with or without the phone connected to an ABM- 200. To access saved reports, press the three bar menu button in the upper left hand corner of the app. In the dropdown menu, choose History. All of the reports saved are displayed on this page. -
Page 8: Maintenance (Change Battery/Cleaning/Storing)
Step one: Pull lip of blue sleeve out of fan groove. This may require the use of a small flathead screwdriver. Step two: Remove sleeve by pulling it over the top of the ABM-200 and off of the bottom. Step three: On the back side of the ABM-200, remove the battery door by pulling it downward. - Page 9 Use a damp rag with mild detergent and wipe down exterior. Do not clean with the sleeve on the ABM-200, as water could enter the sensor port, causing damage and voiding the warranty. Storage The ABM-200 is to be stored out of direct sunlight in temperatures between 32° and 95° F (0° and 35° C).
-
Page 10: Troubleshooting
Troubleshooting PROBLEM POSSIBLE CAUSE CORRECTION Low/dead battery Replace battery Turn on phone’s Bluetooth Bluetooth off ABM-200 not found Pairing not performed Un-pair in OS and pair through app through app Low battery Replace battery Correct AK adjust Incorrect AK %... -
Page 11: Technical Data
Technical Data Operational temperature range: -40°F to +185°F (-40°C to +85°C) Operational temperature range, full accuracy: -32°F to +149°F (0°C to +65°C) Power: Panasonic 3.6V, CR 2450 Coin Cell Lithium Battery Battery Life: >500 hours Auto power: Shuts off 30 seconds after closing or minimizing app or no connection Units of Measure: inWC, inHg, psi, mmWC, mmHg, Pa, kPa, mBar, fpm, cfm, l/s, m/s, F, C, RH%, lb/ft3 Range &... -
Page 12: Glossary
Glossary Airflow Velocity: speed in which the air is being moved into or out of the duct. Airflow Volume: amount of air being moved into or out of a duct in a given amount of time. Humidity: a quantity representing the amount of water vapor present in the air. AK-factor (K-factor): amount of space blocked by a grill or other duct cover.