Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Cengar PL905
Summary of Contents for Cengar PL905
-
Page 2: Ec Declaration Of Conformity
Based on the following Harmonised Standards: EN13463-1:2009 And therefore complies with the essential requirements of those directives. Additional Information: ATEX Coding II 2G T5 Certificate No. TRAC09ATEX21236X Technical File No. CEEX-0803 Authorised Signature: Date: 15/12/09 Title of Signatory: General Manager - Cengar Ltd. -
Page 3: Specifications
Cengar Air Saw Model PL 905 We recommend normal safe working practices should be followed as per the Health and Safety at Work Act, or the appropriate National and State Laws. We recommend that eye protection be worn when using Cengar Saws... - Page 4 Think safe Act safe Be safe LUBRICATION Use Cengar Green Oil with longer lasting coating properties for best results. Cengar Green Oil is specially prepared to: - Emulsify the water generally found in compressed air lines. Give perfect mist lubrication.
-
Page 5: Operating The Saw
Very little maintenance is required if the correct oil is used, but incorrect oil will soon breakdown into sludge, slowing down the action of the saw, necessitating its removal by use of Cengar M.S. Cleaner. It is imperative that the saw is re-oiled immediately after... - Page 10 IF THE SAW DOES NOT OPERATE 1 Check that the isolator is switched on. 2 Check air supply is correct. 3 Valve in handle (part no. 50034) could be worn and/or the seal is broken, blocking an air passage. Check and replace if necessary.
- Page 11 Complete with retaining screw and Détente spring, This has the seat bonded in place already, and can be fitted in seconds. Always remove the saw from the airline before commencing any maintenance work. Only fit genuine Cengar parts and accessories, or safety may be compromised...
- Page 12 NEVER use excessive force, this may increase vibration above safe levels NEVER hold the Cengar saw in a vice by the body, this will distort the bores, rendering the tool inoperative. NEVER screw nameplates to the body, as the screws may penetrate an airway or bore.
- Page 13 ALWAYS ALWAYS use Cengar green oil for best results. Keeping the saw clean and well oiled will give excellent reliability, and a long life. ALWAYS use Cengar Bi-Metal Shatterproof blades, for safety, and best cutting performance ALWAYS isolate the air supply when changing blades.
-
Page 14: General Rule
Cengar Blade selection for cutting solid material Available blade pitches Thickness 10-14 TPI (mm) Varipitch 32 TPI 24 TPI 18 TPI 14 TPI 10 TPI 8 TPI 6 TPI The numbers in the coloured boxes indicates the actual number of teeth in contact... -
Page 15: Saw Blades
A range of 19 mm deep blades could be fitted in certain circumstances. Replace the nosepiece 5045 with 5075 to use 19 mm blades Cengar Green Oil GO 9107P Cengar Green Oil 250 ml plastic bottles for all air tools GO 9109 As above in 5 litre container GO 9110 As above in 25 litre container M.S. - Page 16 SERVICE We offer a full factory repair and refurbishment service for Cengar Saws, - normally within 5 working days. Quotations at no charge can be given before work is carried out. DISTRIBUTOR ADDRESS Cengar Ltd. 70 Lister Lane Halifax, England . HX1 5DN Tel: 01422 354626 Fax: 01422 349024 enquiries@cengar.com...