Table of Contents
Advertisement
Blank screen
•
Make sure you have connected the component to the TV correctly.
•
Make sure the component connected to the TV is turned on and tuned to the corresponding Video Input
Channel.
•
Try another channel, or press the INPUT or ANT•CAB button.
Unusual sound quality
•
Check the Graphic Equalizer, SRS, and Sound Logic settings.
•
Check if SAP is turned on.
•
Check that the Audio Mode is set to your language.
Humming or buzzing noise
•
Maybe the speakers are turned off. Check the FIXED/VARIABLE OUT control panel in the Audio menu.
No sound, picture okay
•
Maybe the sound is muted. Try pressing the volume up button to restore sound.
•
Maybe the speakers are turned off. Check the FIXED/VARIABLE OUT control panel in the Audio menu.
•
If using an S-Video connection, component video and composite video, remember to also connect the
component's L and R AUDIO OUT jacks to the TV's L and R INPUT jacks.
•
Check the Maximum and Initial Volume settings in the Special Features menu.
Channel search finds few channels
•
The cable connected to the CABLE and/or ANTENNA INPUT jack might be loose.
•
Your off-air antenna might be getting a weak signal. Move it higher or get a bigger antenna.
•
If you have cables connected to the CABLE and ANTENNA jacks, try swapping the cables. Cable needs to be
connected to the CABLE INPUT; off-air antenna needs to be connected to the ANTENNA INPUT.
•
If you have a cable box, you can't connect it to the ANTENNA jack. Connect it to the CABLE INPUT or a Video
Input jack.
•
Select all the options in the Channel Search menu, and retry channel search.
Can't select certain channel
•
May be blocked or not approved in the Parental Controls menu.
•
If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR or
INPUT button on your VCR).
•
You usually can't change channels when a menu is on the screen (press the CLEAR button).
Noisy stereo reception
•
May be a weak station. Use Audio menu to choose Mono sound.
No picture, no sound but TV is on
•
Maybe the cable/antenna option wasn't chosen in the Channel Search menu. Select Detect antenna or cable
setting in the Channel Search menu and run the search again.
•
The channel might be blank — change channels.
•
If you're watching your VCR and it's connected with coaxial cable to the CABLE/ANTENNA jack, tune the TV to
channel 3 or 4 (whichever channel is selected on the 3/4 switch on the back of your VCR). Also check to make
sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).
•
If a channel doesn't exist and you tune to scrambled QAM channel, Unusable Signal appears.
Chapter 5
References
61
Advertisement
Table of Contents
