Panasonic CF-73JCLTXKM Operating Instructions Manual page 12

First-time Operation
12
Select settings for your region, then select [Next].
3
Enter your name and organization and then select [Next].
4
Enter your computer name and administrator password and then select [Next].
5
CAUTION
Remember this password! If the password is forgotten, Windows cannot
be operated.
Enter the correct date, time and time zone, then select [Next].
6
NOTE
It may take two to three minutes until the next screen is displayed. Wait,
and do not press any keys, or touch the touch pad, etc.
At [Networking Settings], select [Typical settings], then select [Next].
7
At [Workgroup or Computer Domain], select [No, this computer is not on a
8
network, or is on a network without a domain], then select [Next].
The computer will restart.
NOTE
If "Yes, make this computer a member of the following domain" is se-
lected, the following message may be displayed: [An invalid domain was
specified. Would you like to proceed for now and try joining a domain
later?]. In this case, select [Yes]. After selecting [Yes], the computer will
restart automatically, but sometimes the [Starting Windows] message will
remain on the screen, and windows will not start up. If this happens, hold
Tab down while pressing Alt until [Network Identification Wizard]
is displayed on top, and follow the instructions on the screen.
Enter your administrator password and select
9
Windows 2000
CAUTION
Do not press any key or move the touch pad until [Windows 2000 Professional
Setup] is displayed.
At the [Welcome to the Windows 2000 Setup Wizard], select [Next].
1
After reading the agreement, select [I accept this agreement] or [I don't accept this
2
agreement], then select [Next].
NOTE
If [I don't accept this agreement] is selected, the Windows setup will be
aborted.
Select settings for your region, then select [Next].
3
Enter your name and organization and then select [Next].
4
Enter your computer name and administrator password and then select [Next].
5
CAUTION
Remember this password! If the password is forgotten, Windows cannot
be operated.
Enter the correct date, time and time zone, then select [Next].
6
At [Networking Settings], select [Typical settings], then select [Next].
7
At [Workgroup or Computer Domain], select [No, this computer is not on a net-
8
work, or is on a network without a domain], then select [Next].
The computer will restart.
At [Welcome to the Network Identification Wizard], select [Next].
9
.