Selecting And Interpreting Run Mode Display - Honeywell DPR180 Product Manual

3.4

SELECTING AND INTERPRETING RUN MODE DISPLAY

3.4.1 INTRODUCTION
The recorder allows you to choose between a lot of display types when in the normal scanning mode. At the
end of the power display sequence (see section 3-3, "POWER UP"), the display will be in the scanning
mode, in the display type you have selected in the configuration matrix of the display (Parameters: DISPLAY
HI, DISPLAY LO).
To select another display type (for the lower and/or the upper display), use the DISPLAY key (See next
section 3.4.2 ) or use the configuration mode.
3.4.2 How to select a display type
The immediate action keys are not available if you are in configuration mode.
•
The selection of the DISPLAY key is lost at the power off.
•
Press the DISPLAY key. Then you can read:
•
DISPLAY HI
The upper display is flashing.
DISPLAY LO
The and
•
the ENTER key.
According to your choice, you may obtain:
DISPLAY HI
ANALOG INPUTS
or
DISPLAY LO
ANALOG INPUTS
The and
•
keys allow you to select the desired display. Confirm your choice by pressing
keys allow you to select the desired display mode on the lower display.
Electrical input signal
Electrical input signal
3-4
3. OPERATION