Advertisement
Quick Links
Please dispose of packaging for the product in a responsible
manner. It is suitable for recycling. Help to protect the
environment, take the packaging to the local amenity tip and
place into the appropriate recycling bin.
Oak Wooden Workbench
FOR HELP OR ADVICE ON THIS PRODUCT PLEASE CONTACT YOUR DISTRIBUTOR, OR
SIP DIRECTLY ON:
01441
TEL: 01509500400
EMAIL: sales@sip-group.com or technical@sip-group.com
www.sip-group.com
Please read and fully understand the instructions in this manual
before operation. Keep this manual safe for future reference.
Ref: 020714
12
1
Advertisement
Related Manuals for SIP 01441
Summary of Contents for SIP 01441
- Page 1 FOR HELP OR ADVICE ON THIS PRODUCT PLEASE CONTACT YOUR DISTRIBUTOR, OR SIP DIRECTLY ON: 01441 TEL: 01509500400 EMAIL: sales@sip-group.com or technical@sip-group.com www.sip-group.com Please read and fully understand the instructions in this manual before operation. Keep this manual safe for future reference.
- Page 2 NOTES...
-
Page 3: Contents And Accessories
ASSEMBLY INSTRUCTIONS….cont CONTENTS AND ACCESSORIES Note: The maximum weight the table can take is 300kg. Secure the table-top to the leg-set assembly with 4 x coarse thread bolts with 4 x 8 mm (large) washers, taking Note: If any parts are missing or damaged, contact your distributor for the care not to over-tighten as this will parts to be replaced. - Page 4 CONTENTS AND ACCESSORIES….cont ASSEMBLY INSTRUCTIONS….cont Follow the previous instructions to fit the opposite runner assembly, you may Drawer set: need to lift the drawer slightly in order to ensure that the runner sits in the groove on the drawer, and that the screws line up correctly with the pilot holes. Ref.
- Page 5 ASSEMBLY INSTRUCTIONS….cont ASSEMBLY INSTRUCTIONS Fitting the drawer assembly to the table-top: Take one of the main legs-sets and locate the position for the upper brace (see below). Set the table-top down so that the bottom of it faces upwards. Fit 4 of the supplied wood screws into the 4 x holes on one of the drawer runner assemblies.
- Page 6 ASSEMBLY INSTRUCTIONS….cont ASSEMBLY INSTRUCTIONS….cont Assembling the drawer set: Rear lower brace groove Take the front section of the drawer and lay it with the front facing down. Select one of the drawer sides and sit it in-place against the front section. Slide the main shelf in between the groove on the rear lower brace.
Need help?
Do you have a question about the 01441 and is the answer not in the manual?
Questions and answers