Whelen Engineering Company WPA112 Installation Manual

Whelen Engineering Company WPA112 Installation Manual

Waterproof amplifier, wpa series

Advertisement

Quick Links

ENGINEERING COMPANY INC.
51 Winthrop Road
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Canadian Sales e-mail: autocan@whelen.com
Customer Service e-mail: custserv@whelen.com
DANGER!
Sirens produces extremely loud emergency warning tones! Exposure to these
tones without proper and adequate hearing protection, could cause ear damage and/or hearing
loss! The Occupational Safety & Health Administration (www.osha.gov) provides information
necessary to determine safe exposure times in Occupational Noise Exposure Section 1910.95.
Until you have determined the safe exposure times for your specific application, operators and
anyone else in the immediate vicinity should be required to wear an approved hearing protection
device. FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!
Safety First
This document provides all the necessary information to allow your Whelen product to be properly and safely installed.
Before beginning the installation and/or operation of your new product, the installation technician and operator must
read this manual completely. Important information is contained herein that could prevent serious injury or damage.
Proper installation of this product requires the installer to have a good understanding of automotive electronics,
systems and procedures.
If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components or other
vital parts could be damaged by the drilling process. Check both sides of the mounting surface before drilling
begins. Also de-burr any holes and remove any metal shards or remnants. Install grommets into all wire
passage holes.
If this manual states that this product may be mounted with suction cups, magnets, tape or Velcro®, clean the
mounting surface with a 50/50 mix of isopropyl alcohol and water and dry thoroughly.
Do not install this product or route any wires in the deployment area of your air bag. Equipment mounted or
located in the air bag deployment area will damage or reduce the effectiveness of the air bag, or become a
projectile that could cause serious personal injury or death. Refer to your vehicle owner's manual for the air bag
deployment area. The User/Installer assumes full responsibility to determine proper mounting location, based
on providing ultimate safety to all passengers inside the vehicle.
For this product to operate at optimum efficiency, a good electrical connection to chassis ground must be
made. The recommended procedure requires the product ground wire to be connected directly to the NEGATIVE
(-) battery post.
If this product uses a remote device to activate or control this product, make sure this control is located in an
area that allows both the vehicle and the control to be operated safely in any driving condition. DO NOT
ATTEMPT TO ACTIVATE OR CONTROL THIS DEVICE IN A HAZARDOUS DRIVING SITUATION.
It is recommended that these instructions be stored in a safe place and
referred to when performing maintenance and/or reinstallation of this
product.
FAILURE
TO
FOLLOW
INSTRUCTIONS COULD RESULT IN DAMAGE TO THE PRODUCT OR
VEHICLE AND/OR SERIOUS INJURY TO YOU AND YOUR PASSENGERS!
For warranty information regarding this product, visit www.whelen.com/warranty
©1997 Whelen Engineering Company Inc.
Form No.13236F (050608)
®
THESE
SAFETY
PRECAUTIONS
Page 1
Installation Guide:
WPA™ Series Waterproof Amplifier
ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!
AND
Loud siren noise can cause
hearing damage and/or loss.
Wear
Refer to OSHA Section 1910.95 prior
to putting ANY siren into service!
Protection!
CAUTION

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WPA112 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Whelen Engineering Company WPA112

  • Page 1 VEHICLE AND/OR SERIOUS INJURY TO YOU AND YOUR PASSENGERS! Wear Refer to OSHA Section 1910.95 prior to putting ANY siren into service! Protection! For warranty information regarding this product, visit www.whelen.com/warranty ©1997 Whelen Engineering Company Inc. Form No.13236F (050608) Page 1...
  • Page 2 Connecting To Your Speaker: This manual outlines the procedures necessary for the installation of the WPA Series Waterproof Amplifier. This includes the 100 Watt models (WPA112, WPA124) and 58 Watt Route the ORANGE and BROWN wires towards your models (WPA512 and WPA524). speaker.
  • Page 3 Wiring The WPA™ Series Waterproof Amplifier To The Controls If the WPA series control head (optional) is not used, siren configuration and functionality are determined by user supplied switches connected to the WPA amplifier. A brief explanation of each of the function wires will serve as a guide to help determine the best configuration for your specific needs (see table 1): RED/WHITE Provides current for customer...
  • Page 4 “ramps up” to a predetermined level and continues at that level until the manual switch is released. When the switch is released, the tone is immediately terminated. REAR VIEW OF THE AMPLIFIER SIREN SPECIFICATIONS SPEC: WPA112 WPA124 WPA512 WPA524 INPUT VOLTAGE 13.5 VDC ± 20% 26.5 VDC ±...

This manual is also suitable for:

Wpa124Wpa512Wpa524

Table of Contents