Slave Mode; Maintenance; Troubleshooting - MBT LEDMOONDOG User Manual

SLAVE mode ( Master and Slaves synchronize)
Notes: 1.Set DMX address by switch1~9 .
2.When switch10 is ON, it is DMX mode. Otherwise it is master mode.

MAINTENANCE

Troubleshooting

Problem
Fixtures does not work
Reset normally,
controller abnormally or no
response
Probable cause(s)
No power source
Fuse burnt
False or incomplete
data connection
False address setting
but
Problem of signal cord
of some fixtures
Signal output does
not match with the pin
(pins2 and pins3 has a
wrong sequence)
10
Suggested remedy
Check if power source is on and
power cord is connected well.
Cut off power source and change
the same type fuse. If fuse was
burnt on end, it may be the
problem of line connection
Check the data line.
Ensure connection of data line is
right and the first lamp's single
input is connected
controller output.
Check DMX address.
Pull out signal line and butt joint,
trying to find malfunctioned lamp
one by one. Or contact with
professional technicians.
Toggle the PHASE button on the
controller to reverse the polarity.
with the