Table of Contents
Advertisement
AUTO CHANNEL SEARCH
Go Back
Channel List
Signal Source
Ana. Sig Type
Dig. Sig Type
Start
Progress
Channel
Channels Found
The Master menus are available while
using the Master Remote (R130K2).
TIME
Go Back
Time
Time Access
Sleep Timer
Wake-Up Timer
Wake-Up Time
Wake-Up Ch.
Schedule
Chapter 1
Place all available Channels Into Memory
1.
To go to the Setup menu, with the master remote (R130K2), press MENU
then select Auto Channel Search. In this menu you'll be able to set your
List A...
Signal Source. Choose from Analog, Digital or Both. This choice will depend
Both...
on what connections you've made to the ANTENNA/CABLE ANALOG
INPUT and/or the ANTENNA/CABLE DIGITAL INPUT jacks. Now set
Cable...
your signal type. The TV will search for all channels viewable through your
Antenna...
antenna or cable TV system.
Running...
2. Scroll up to select which channel list you'd like to find channels for (List A is
21%
the default).
012
16
3. Press the down arrow button to select Start. Press the OK button to start
searching. The TV searches for active channels and places them in the
channel list.
Note: Video Input Channels (VID, SVID, etc.) must be added to the
active channel list separately before they can be accessed. Refer
to the Setup menu section at the end of this chapter for more
information on the Channel menu and List & Labels.
Set the Time
The current time options might not be available to the basic user, depending on
how they've been set by the master user.
08:00 am
To set the time, from the Main menu select Time. If the current time has not been
Basic
set, use the arrow and number buttons on the remote control to set it.
Off
1.
From the Main menu, highlight Time and press OK.
2.
Time is highlighted. To set the time, use the number buttons to set the hour.
07:00 am
Press the right and left arrow button to add or subtract minutes. The OK
08
button changes am and pm.
...
Note: The Wake-Up Timer and Wake-Up Time options are
unavailable unless Time has been set.
The ClonePRO™
If several TVs need to be programmed with the same menu settings, an optional
ClonePRO remote can be used to copy all of the menu settings from one TV into
other TVs to reduce installation time. Information can be both downloaded to
and uploaded from the ClonePRO using the DSCI port on the TV's back panel
or using the IR sensor. A ClonePRO can be obtained from your RCA commercial
distributor. Chapter 2 has information about this remote, see page 20. If you
want to set other menu options before using the ClonePRO, continue on in this
chapter. You can use the ClonePRO at any time.
Connections & Setup
Advertisement
Table of Contents
Troubleshooting
