Table of Contents
Advertisement
Phone Jacks
Connections & Setup
Audio/Video Jacks
I
Y
P B
P R
TV ANT
Digital Audio
Out Jack
TV ANT
Phone Jacks
Plug in the TV
Y
P B
P R
Plug the end of the power cord into a grounded wall outlet. Insert the plug completely into the outlet.
Start-up
The steps below get your TV connected and ready to watch.
Put Batteries in the Remote
1. Slide off the cover of the battery compartment.
2. Place the two AAA batteries into the remote, matching the + and – end of each battery in the compartment.
3. Replace the cover.
Turn on the TV
Press POWER on the TV or remote.
8
•
TV ANT Used to attach either an antenna or cable system to the TV. To connect a
VCR, connect a coaxial cable to the TV ANT jack on your TV and to the Output Jack on
the VCR (sometimes labeled OUT TO TV).
•
R and L/MONO AUDIO and VIDEO Their description is the same as VIDEO 1.
AUDIO/VIDEO OUTPUTS Allow connection of external audio amplifiers, power
speakers, audio receivers for improved sound quality or an external video monitor with the
use of VIDEO OUT. Please note that these outputs cannot drive standard speakers directly.
DSCI
Port
DSCI PORT This port is used to transfer information between a TV and other devices,
such as a clone box or interactive system. This port is an eight-pin telephone-type port.
When the TV receives a message via the DSCI (digital serial communications interface) port,
it will act in accordance with the digital instructions received. For more information on its
connection and operation, please contact your distributor or the supplier of the interactive
system.
TV ANT
Chapter 1
Advertisement
Table of Contents
