Table of Contents
Advertisement
Using the ClonePRO™
DSCI (green) buttons
Comm Restores the TV to normal commercial operation, essentially undoing the effect of the LEGACY and DECOM
buttons.
Decom "Decommercializes" the TV to facilitate aftermarket resale.
[Factory] This button has no functionality with this product.
LEARN Begins the process of learning the settings from a TV that has been setup as desired.
Note: Pressing LEARN overwrites any settings already in the ClonePRO.
Legacy Places the TV in a mode in which it emulates the behavior of older models. This is a required part of the
configuration for some applications.
POWER Turns on the TV. It is recommended, though not required, when in DSCI mode to view on-screen displays.
[Status]: Press and hold the INFO button for several seconds to display settings stored in the ClonePRO and the TV. For example:
Mem:
CB:36
TV:36
This tells you the ClonePRO and the TV have 36 pages of information stored in memory.
Chapter 5
Graphics contained within this publication are for representation only.
Chapter 5: Other Information
Modes of operation
The ClonePRO operates from one of two modes:
DSCI
Connect a DSCI cable to the ClonePRO and to the TV's DSCI port
on the back panel.
IR (Infrared) This operation is wireless. Press ON to begin using the
remote in IR mode.
The corresponding "ready" light indicates the mode of operation, and the
corresponding "busy" light indicates activity in this mode.
Buttons with black labels function similarly in both modes, while green labels
operate DSCI mode and red labels operate IR mode.
DSCI mode
The ClonePRO enters this mode when it is connected to the TV's Digital Serial
Communications Interface port via a cable (included).
• Any standard (no-flip, 1-to-1) 8-conductor computer-networking cable
may be used.
• No battery is required in this mode.
• If the unit is already in IR mode, press OFF to speed the transition to
DSCI mode.
Other Information
Continues on next page...
31
Advertisement
Table of Contents
