Speaker Connections - PHD 2260X Owner's Manual & Installation Manual

0.5 meters from the battery. This fuse is to protect the car not the electronics. In case of a
short, the fuse will blow instead of the wire burning up. Using other than the recommended
void your warranty.
Do not run wiring underneath or outside the car since exposure to the elements may cause
the insulation to deteriorate rapidly, resulting in short-circuits and/or intermittent operation.
all cables should be run beneath carpets and inside trim pieces.
To help minimize interference, it is best to run the power cables along the opposite side
from the audio cables
Whenever wires pass through metal, rubber or plastic grommets must be used to prevent
the metal from wearing through the installation and causing a short.
Whenever possible, use cable ties, mounting clamps and similar wiring aids. (available
from an electrical supply or auto parts store) Adding stress relief loops to wiring is also
advisable to prevent straining or breakage.
If the temperature inside your car reaches extreme levels(such as sitting locked up for
into protection mode and shut off. Leave the unit off until the ambient temperature returns
to normal.
not sure of the type of electrical system in your vehicle, consult your authorized dealer or
NEVER ground the speaker leads and NEVER allow the speaker leads to come in contact
With each other. Speaker wire should be 18 gauge or larger.
Remote turn on wire must be switched by the radio does not have a remote turn on or
antenna output, connect to wire that has a positive 12 volts when the key is turned to the
Do not listen to high volumes for extended periods of time or hearing damage may occur.
C O N T I N U O U S E X P O S U R E TO S O U N D P R E S S U R E L E V E L S O V E R 1 0 0 d B M AY
CAUSE PERMANENT HEARING LOSS. HIGH POWERED AUTOSOUND SYSTEM
MAY PRODUCE SOUND PRESSURE LEVELS WELL OVER 130dB. USE COMMON
SENSE AND PRACTICE SAFE SOUND.
-3-

SPEAKER CONNECTIONS

CAUTION
.
ADJUSTMENTS
The frequencies below the crossover point will be attenuated at 12dB/octave. Permits
ad justment of the crossover frequency ,by rotating the knob to select any frequency
between 50Hz to 1.2kHz as the crossover point
above the crossover point will be attenuated at 12dB /octave. Permits adjustment of the
crossover frequency, by rotating the knob to select any frequency between 50Hz to 250Hz
as the crossover point .
The full frequency band width (20Hz - 20kHz) will be output to the speakers without high
or low frequency attenuation.
different brands of head units. It allows input signal to vary between 250 millivolts to 8
volt from the head unit or other signal processor. Start by setting the sensitivity adjustment
to the "MIN" (8 volts).Using a cassette or compact disc that you are familiar with ,turn on
he ad unit to the 3/4 volume setting. Slowly turn up sensitivity adjustment towards the
and turn back just a slight. The 3/4 volume setting is now the "maximum" volume for the
head unit. The goal is to keep the level control to the lowest setting yet still have enough
system noise to a minimum. It is important not over drive speakers (at point of distortion)
it could be damaged.
5.The "BASS" function can be selected to increase low frequency response output, or
decrease frequency response output. The "BASS" function will be working at only "FULL"
or "LPF" position.
The BASS is adjustable from 0 ~ 12dB boost at 50Hz.
.
-12-