Using The Who•Input Button - RCA F27669 User Manual

ON•OFF Turns the TV on and off. When the remote is in another mode (VCR, DVD, Satellite, etc.)
Tip
and the remote is programmed to operate that component, you can press ON•OFF to turn the
To turn off all the
component on and off.
RCA, GE, and
PROSCAN PAUSE If you're operating a VCR or DVD Player with the remote control, press PAUSE when the disc
components that are
or videotape is playing to pause playback.
connected to the TV,
press ON•OFF twice PIP (Picture-In-Picture) Brings up the small Picture-In-Picture window. Press again to remove the
within two seconds.
PIP window.
This feature only
PLAY If you're operating a VCR or DVD Player, plays the disc or videotape.
works with most RCA,
GE and PROSCAN
REC•VCR+ When the GUIDE Plus+ program guide is on the screen, press REC•VCR+ to program
products.
your VCR to record a program. If the remote is in VCR mode, press REC•VCR+ to start recording.
RESET Resets original settings in several control panels.
REVERSE If you're operating a VCR or DVD Player with the remote control, press REVERSE to go
backwards on a disc or videotape.
SAT•CABLE Puts the remote in SAT•CABLE mode. If you set up the Auto Tuning feature (Chapter
3), pressing the SAT•CABLE button automatically tunes the TV to the correct channel.
SKIP If you press this button before you change the channel, the TV waits 30 seconds and
automatically goes back to the original channel. Each time you press SKIP, you add 30 seconds (i.e, if
you press SKIP two times before you change the channel, the TV waits 60 seconds and automatically
turns back to the original channel).
SOUND Displays the AUDIO PROCESSOR menu.
STOP If you're operating a VCR or DVD Player, stops playing the disc or videotape.
SWAP Switches the main picture with the PIP window.
TV Turns on the TV and puts the remote in TV mode. Also displays channel information.
VCR1 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR1 button automatically tunes the TV to the correct channel.
VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR2 button automatically tunes the TV to the correct channel.
VOL (up and down) buttons Decrease or increase the TV's volume.
WHO•INPUT In TV mode, press WHO•INPUT to toggle through the available Video Input
channels (FRNT, VID1, VID2, SVID and the current channel). In SAT mode, press to select available
channel lists.
Using the WHO•INPUT Button
Use the WHO•INPUT button to toggle through the available input sources (FRNT, VID1, VID2, SVID
and the current channel) and view the content from the component you have connected to the TV.
1. Press TV to place the remote in TV mode. Make sure that the content from the component is
2. Press WHO•INPUT to tune to the available input source and view the component.
3. Press WHO•INPUT again to tune back to the channel you were previously watching.
Chapter 2
turned ON.
Using the Remote Control
23