Related Manuals for ACKme Networks AMW004-E02 Marlin
Summary of Contents for ACKme Networks AMW004-E02 Marlin
- Page 1 AMW004 Evaluation AMW004 Evaluation Guide AMW004-E02 AMW004-E03 ‘Marlin’ ‘Mackerel’ ARG-MW004E-105R • AMW004 Evaluation Guide February 27, 2015 ©2014 ACKme Networks. http://ack.me...
- Page 2 While the information provided in this document is http://ack.me/contact believed to be accurate, it is under development and ACKme Networks reserves the right to make changes About this User Guide without further notice to the product described herein to improve reliability, function, or design, and makes no...
-
Page 3: Table Of Contents
Revision History & Glossary ......... 16 Revision History ..........16 Glossary ............16 APPENDIX A – Configuring a Terminal Application APPENDIX B – Evaluation Board Schematics ARG-MW004E-105R • AMW004 Evaluation Guide Page | ii ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 4: Introduction
The module runs WiConnect firmware, ACKme Networks easy-to-use and reliable serial Wi-Fi networking application that includes an embedded TCP/IP networking stack with SSL/TLS/HTTPS security. -
Page 5: Feature Identification
2 Not connected to AMW004 by default. R8 must be populated with a 0R link to make the connection. 3 The silkscreen is WRONG! Button 1 is actually connected to Pin 8 of the expansion header. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 2 ©2014 ACKme Networks. http://ack.me February 27, 2015... - Page 6 GPIO_26 WAKE GPIO_12 GPIO_12 GPIO_25 GPIO_25 GPIO_22 GPIO_22 GPIO_0 GPIO_0 GPIO_21 GPIO_21 GPIO_16 USART1_CTS GPIO_18 SPI_MOSI Notes Connection to AMW004 is via a 220R resistor ARG-MW004E-105R • AMW004 Evaluation Guide Page | 3 ©2014 ACKme Networks. http://ack.me February 27, 2015...
-
Page 7: Amw004-E03 'Mackerel
20 at the antenna end: E03.1 H2 pin 1 = E03.2+ H2 pin 19, E03.1 H2 pin 2 = E03.2+ H2 pin 20, and so on. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 4 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 8: Using Wiconnect
: Initiate a Wi-Fi scan and return results; optionally specify a channel and AP SSID to scan for. For verbose scans, -v must be the first argument ARG-MW004E-105R • AMW004 Evaluation Guide Page | 5 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 9: System Indicator Leds
. WiConnect starts the local network and web server as indicated by the final message: In progress > setup web [Disassociated] IPv4 address: 10.10.10.1 ARG-MW004E-105R • AMW004 Evaluation Guide Page | 6 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 10: Script Setup
WiConnect file system. The setup script may be customised as required. > setup cmd > Enter Wi-Fi network name: set wlan.ssid YOUR_NETWORK_NAME Set OK > Enter Wi-Fi network password: set wlan.passkey YOUR_NETWORK_PASSWORD Set OK > ARG-MW004E-105R • AMW004 Evaluation Guide Page | 7 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 11: Manual Setup
Be sure to save afterwards, or the values will be lost when the module reboots. Any subsequent command requiring network access, such as an ICMP (Internet Control Message Protocol) ping, automatically results in the module attempting to join the network. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 8 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 12: Wireless Protected Setup (Wps)
/setup/index.js.gz 32251 1.2.0 command_help.csv 1.2.0 default_setup.script 1236 1.2.0 geotrust_ca.pem 1.0.0 hello.txt 9 352516 1.2.0 upgrade_app.exe # 10 109600 1.2.0 wiconnect.exe # 11 191677 1.2.0 wifi_fw.bin ARG-MW004E-105R • AMW004 Evaluation Guide Page | 9 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 13: Udp / Tcp / Tls Clients
> stream_write 0 1 Success > stream_read 0 50 !"#$%&'()*+,-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQR Note! WiConnect supports TCP server mode too! For more information, please refer to the WiConnect Reference Guide. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 10 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 14: Http / Https Clients
(standard IO) or by disabling the alternate function. The example below demonstrates how to control GPIO 26 on the AMW004 module. GPIO 26 is unassigned GPIO after factory reset. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 11 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 15: Factory Reset
Set OK > reboot [Disassociated] Rebooting wiconnect-1.1.0.5, Built:2014-05-07 00:07:31 for AMW004.3, Board:AMW004-E03.1 [Ready] > get wlan.ssid > set wlan.ssid ssid_WILL_be_saved Set OK > save Saved ARG-MW004E-105R • AMW004 Evaluation Guide Page | 12 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 16: 3.11 Command Vs. Stream Mode
Disable/enable a response header set system.cmd.prompt_enabled Turn on/off the user prompt set system.cmd.echo Turn on/off character echo. In human mode, lets you see what you're typing ARG-MW004E-105R • AMW004 Evaluation Guide Page | 13 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 17: Stream Mode
A number of simple and more sophisticated example applications are also provided to help you get the most out of WiConnect and the AMW004 module. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 14 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 18: Ordering Information
AMW004 module. This board is similar to the AAE001 Marlin board but is instead fitted with a surface mount AMW004 module that is not removable. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 15 ©2014 ACKme Networks. http://ack.me February 27, 2015... -
Page 19: Revision History & Glossary
November 21, 2014 Add System Indicator LEDs section Glossary In most cases, acronyms and abbreviations are defined on first use. A comprehensive list of acronyms and other terms used in ACKme Networks documents are provided on the ACKme Networks website at http://ack.me/FAQs/Glossary. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 16 ©2014 ACKme Networks. -
Page 20: Appendix A - Configuring A Terminal Application
VCP driver to load correctly. If the FTDI drivers do not appear to be installed, see the installation instructions on the FTDI official site: http://www.ftdichip.com/Support/Documents/InstallGuides.htm ARG-MW004E-105R • AMW004 Evaluation Guide Page | 17 ©2014 ACKme Networks. http://ack.me February 27, 2015... - Page 21 The COM Port shown in the example (COM14) will almost certainly be different for your evaluation board, be sure to choose the COM port that matches your board. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 18 ©2014 ACKme Networks. http://ack.me February 27, 2015...
- Page 22 Tera Term displays ‘COM14:115200baud’. The Tera Term screen remains blank however until a character is sent to WiConnect. Try pressing the Enter key, WiConnect responds with Ready as shown in the following screen capture. ARG-MW004E-105R • AMW004 Evaluation Guide Page | 19 ©2014 ACKme Networks. http://ack.me February 27, 2015...
- Page 23 Try pressing the Enter key, if CoolTerm is successfully connected to the evaluation board, WiConnect responds with Ready > ARG-MW004E-105R • AMW004 Evaluation Guide Page | 20 ©2014 ACKme Networks. http://ack.me February 27, 2015...
-
Page 24: Appendix B - Evaluation Board Schematics
Appendix B – Evaluation Board Schematics & Mechanical Dimensions ARG-MW004E-105R • AMW004 Evaluation Guide Page | 21 ©2014 ACKme Networks. http://ack.me February 27, 2015... - Page 25 Appendix B – Evaluation Board Schematics & Mechanical Dimensions ARG-MW004E-105R • AMW004 Evaluation Guide Page | 22 ©2014 ACKme Networks. http://ack.me February 27, 2015...
- Page 26 Appendix B – Evaluation Board Schematics & Mechanical Dimensions ARG-MW004E-105R • AMW004 Evaluation Guide Page | 23 ©2014 ACKme Networks. http://ack.me February 27, 2015...
- Page 27 Appendix B – Evaluation Board Schematics & Mechanical Dimensions Mechanical Dimensions for AMW004-A01 ‘Hornet’ ARG-MW004E-105R • AMW004 Evaluation Guide ©2014 ACKme Networks. http://ack.me...
- Page 28 ACKme Networks Contact Information +1 (408) 402 5708 US Headquarters http://ack.me/contact 2 North Santa Cruz Ave Suite #207 Los Gatos CA 95030 Phone: © 2014 ACKme Networks Inc. All rights reserved. • ARG-MW004E-105R AMW004 Evaluation Guide February 27, 2015...