Table of Contents
Advertisement
Connections & Setup
16
1571963A.01 Setup
3. Highlight the channel to which you have to tune your
TV in order to see cable programming, and press OK
(a screen appears reminding you to connect your G-
LINK cable to your TV and cable box).
Notes: Channel 03 is the most common.
Choose Video1/AUX if your cable box is
connected to your TV with audio/video cables
instead of a coaxial cable. Go to page 7 for
pictures of these cables.
4. Highlight your brand of cable box, and press OK.
If your brand isn't listed, highlight Not Listed and
press OK.
5. Make sure your cable box is on.
Tune the cable box to channel 02 (use the remote
control that came with your cable box, or press the
channel buttons on the cable box).
Press OK (the GUIDE Plus+ system starts testing
codes).
Important Note: When code testing is in
progress, don't touch your TV, VCR, cable box
or any of the remote controls for these
products.
6. Look at your cable box. If it is still on and changed to
channel 09, the test was successful. Highlight Yes,
and press OK (STEP 3: Configuring for a VCR
appears).
If your cable box didn't change to channel 09 or
turned itself off, you have two choices: No and Test
this code again.
Test this code again: If you think the TV, the
cable box, or any of the remote controls might
have been touched or bumped during the test,
highlight Test this code again and press OK (the
GUIDE Plus+ system runs the same set of codes).
No: If you don't think the test was interrupted,
highlight No and press OK (GUIDE Plus+ system tests
the next code).
Repeat the previous instructions until the TV finds the
correct cable box code. Follow the instructions on the
screen.
Note: If the TV can't find your cable box
code, a troubleshooting checklist appears.
Carefully review each checklist and follow
the instructions on the screen.
16
Chapter 1
4/9/02, 12:58 PM
Advertisement
Table of Contents
