Restore Factory Default Settings - Watchguard Firebox M200 Hardware Manual

To install your Firebox in a network rack:
1. Locate the two rack ears and eight mounting screws included with your Firebox.
To attach each rack ear to the Firebox, use two large and two small screws
2. Align the four holes in a rack ear with the four holes on one side of the Firebox.
3. Use two of the smaller screws to connect the front of the rack ear to the Firebox.
4. Use two of the larger screws to connect the back of the rack ear to the Firebox.
5. Repeat these steps to connect a rack ear to the other side of the Firebox.
6. You can use rack screws and a washer (not included) to attach the rack ears to the rack.
Restore Factory-Default Settings
If you ever need to, you can restore your Firebox to its factory-default settings. For example, if you do not know
the administrator account passphrase or you want to start over with a new configuration, you can reset your
device. Make sure you back up your device configuration before you reset your device in case you want to
restore it in the future.
To reset your device:
1. Power on the device.
2. Wait until the Arm indicator is green.
3. Press and hold the Reset button on the front of the device.
4. Continue to hold the Reset button while the Arm indicator is red.
5. Continue to hold the Reset button while the Arm indicator flashes green once per second.
6. After the Arm indicator flashes green twice per second, release the Reset button.
7. Wait until the Arm indicator starts to flash red.
8. Press and hold the Reset button for five seconds to reboot the device.
Hardware Guide
Use large screws here
.
Use small screws here
Hardware Specifications
7