Subscribe to Our Youtube Channel
Related Manuals for MFC International RC4000
Summary of Contents for MFC International RC4000
- Page 1 RC4000 Rescue Craft Community Design number: 2520494 Product Manual © MFC International 2017...
-
Page 2: Table Of Contents
Operational instructions Packing Storage Maintenance & Test Procedures Repairs WARNING: Carefully read this manual before operating NOTICE: The manufacturer takes no responsibility for the consequences of actions not complying with the instructions given in this manual. © MFC International 2017... - Page 3 SCOPE OF USE. Category D. The Rescue Craft is designed for use in “sheltered waters” in wind speeds up to and including Beaufort scale 4 with a significant wave height (H1/3; in metres) up to and including 0.5m. © MFC International 2017...
-
Page 4: Parts List
Parts list © MFC International 2017... -
Page 5: Materials List
Alloy shaft, HDPE blade, T handle Valise (not shown) PVC coated polyester - Orange HP inflation hose (not 1.0m Reinforced hose c/w C7 valve adaptor shown) Repair Kit (not shown) 70ml Neoprene adhesive, Hypalon patches x4 © MFC International 2017... -
Page 6: Operational Instructions
Motor position (trim) - As a general rule the recommended trim angle should be set so the axis of the propeller shaft is parallel with the water surface when the craft is at operational speed. Trim motor closer to transom when craft is lightly loaded or going into wind. © MFC International 2017... - Page 7 If fuel spills onto the floor of the craft wash off with water. Take care when docking. Arms and legs may be injured if they are outside the craft. Aggressive docking may cause damage to the craft, resulting in air loss. © MFC International 2017...
- Page 8 On board rescue personnel should assist less able casualties. Warning: Ensure the motor is switched off before attempting to board the Rescue Craft in this way. Propellers can cause serious injury. © MFC International 2017...
- Page 9 Warning: The fitting of a motor of greater power than the maximum specified is not permitted. Modification to the Rescue Craft is not permitted without prior written approval from MFC International Ltd. Any non-approved modification will invalidate the warranty and may result in personal injury or death.
-
Page 10: Storage
(e.g. 2 to 3 hours.) After this time, the Rescue Craft should still be firm. If it has become soft, the air-loss should be located by applying a soapy-water solution. © MFC International 2017... -
Page 11: Repairs
RECOMMENDATIONS. Rescue Craft should undergo an annual test carried out by the manufacturer, or people certified by MFC International Ltd. If in doubt contact the service department. Repairs As a general rule, punctures and other damage will need to be assessed in two categories: a) that which is repairable at the base, or b) serious damage that will need to be repaired by MFC International Ltd. -
Page 12: Mfc International
MFC International Naval Yard Tonypandy Rhondda Cynon Taff CF40 1JS T. +44 (0) 1443 433 075 F. +44 (0) 1443 420 448 sales@mfc-international.com www.mfc-international.com SA-MA62 - 01 A Respirex International Limited Group Company...
Need help?
Do you have a question about the RC4000 and is the answer not in the manual?
Questions and answers