Kangaroo Hillcrest ABX Manual page 21

Normal Operation:
1. Prior to beginning play, rotate the Accelerator to the SET position (Figure 8 on page 17). You can vary the
Accelerator to suit your own walking pace after you begin play.
2. Position the Function Switch to ON (Figure 9 on page 17).
3. Position the Function Switch to the MANUAl position when Remote Guidance is not desired.
Manual Mode is recommended when using your X-Series in parking lots, in tight spots, and around
water hazards.
4. Position the Function Switch to the REMOTE position when you are ready to begin play
with Remote Guidance.
5. Press the GO button on the Remote Transmitter. Your X-Series will start and ramp up to your preset speed.
Press GO a second time and your X-series will increase its speed, automatically ramping up to 90% of its
maximum speed (approximately 4.5 mph). Press GO a third time and your X-Series will automatically decrease
to your original preset speed. If you press GO a fourth time, your X-Series will again increase to 90% of its
maximum speed. Each activation of GO while your X-Series is moving will alternate between your preset
speed and 90% maximum speed. (Figure 10)
Cont:
20