Table of Contents
Advertisement
P6-KBD
2.3 KEY PRIORITY PARAMETER
2.3
2.3
2.3
KEY PRIORITY PARAMETER
KEY PRIORITY PARAMETER
KEY PRIORITY PARAMETER
Value of the parameter adjusts incoming MIDI Note On/Off commands processing in case of all six tone
generators of the instrument are being used (all six voices are sounding).
Valid parameter values are 0 to 3:
0
LAST:
Last key priority – the last pressed key always replaces the first key pressed.
1
HIGHER:
Higher key priority – if the last pressed key is of higher tone than any of the previously pressed
keys, the lowest key tone is replaced.
2
LOWER:
Lower key priority – if the last pressed key is of lower tone than any of the previously pressed
keys, the highest key tone is replaced.
3
NONE:
No priority – if all eight tone generators are being used, all Note On commands are ignored at
the MIDI input.
The value of this parameter can be adjusted by MIDI CC #17 (see chapter 3.1.2) or by SysEx message (see
chapter 3.3).
2.4 PITCH BEND RANGE PARAMETER
2.4
PITCH BEND RANGE PARAMETER
2.4
2.4
PITCH BEND RANGE PARAMETER
PITCH BEND RANGE PARAMETER
This parameter adjusts maximum range of the pitch bend controlled by the "Pitch Bend" ("Pitch Wheel") MIDI
2 2 2 2
command
.
Valid parameter values are 0 to 24. The 0 value switches the pitch bend off - MIDI command "Pitch Bend" is
ignored. The values of 1 to 24 set the bend range in semitones, The ±2 octave transposition is available thus.
The value of this parameter can be adjusted by MIDI CC #18 (see chapter 3.1.2 or by SysEx message (see
chapter 3.3).
2.5 ARPEGGIO CLOCK RATE PARAMETER
2.5
ARPEGGIO CLOCK RATE PARAMETER
2.5
2.5
ARPEGGIO CLOCK RATE PARAMETER
ARPEGGIO CLOCK RATE PARAMETER
This parameter selects arpeggiator clock source and adjusts the arpeggiator tempo for MIDI clock
synchronization.
Valid parameter values are 0 to 127.
The value of 0 switches the Polysix's internal clock generator on - the arpeggio speed is adjusted by the SPEED
knob on the instrument's panel or by external clock impulses from the ARPEGGIO TRIG IN connector on the rear
panel.
The parameter values 1 to 127 synchronize the arpeggiator speed according to the incoming MIDI Clock data.
The parameter's value then sets prescaler of MIDI Clock, i.e. number of MIDI Clock pulses for one arpeggiator
step. The value 1 represents 127 MIDI Clock pulses, 2 represents 126 MIDI Clock pulses, etc. up to value 127
which represents one MIDI Clock pulse length of the arpeggiator step. For the conversion rates see Table 2.
The value of this parameter can be adjusted by MIDI CC #19 (see chapter 3.1.2 or by SysEx message (see
chapter 3.3).
2
Pitch Bend MIDI command affects only tones launched by MIDI Notes. Own instrument's keyboard is not affected.
All rights reserved. No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
MIDI Interface for Korg Polysix Keyboard
6
Copyright © 2018 CHD Elektroservis.
Model 8-431 ver. 1.1
Advertisement
Table of Contents
