GP Design P53 User Manual

Battery : 3 x AAA - Alkaline or NiMH
Fitting batteries :
1. Make sure flashlight is off and unscrew the tail cap (A).
2. Remove old batteries and install new batteries in the correct polarity. Insert new batteries according to
the polarity indications (+) and (-) marked on the battery holder. Care to install all three batteries as
described as failure to do this may cause damage to the flashlight.
3. Screw the tail cap back into place. The torch is now ready for use.

Operation :

Full pressing (B)
Half press (B)
When light is on, press (C) to adjust brightness
Press (C) when flashlight Off
Press (C) when light is On

Focus :

Single handed push pull head (D)

Focus lock :

Turn the Head (D) clockwise
Turn the Head (D) anti clockwise
Main switch (B)
Mode switch (C)
P53
Dual switch
Focus lock /
unlock
Tail cap (A)
Light on (100%) ---> Light off
Momentary on
Light on (100%) ---> Light on (50%) ---> Light on (7%)
(the cycle repeats)
Instant strobe. If pressed more than 5 seconds, strobe
remains on. Press again to turn strobe off.
Press Mode switch for more than 3 seconds to activate
Strobe. Strobe remains on until mode switch is pressed
again. The flashlight resets to high output level.
Quick and easy focus
Locks the focus
Unlocks the focus.
Focusable
Head (D)
USER MANUAL
Unscrew tail cap
anti-clockwise to
change batteries