Table of Contents
Advertisement
TL-A8O-50W User Manual
3. System Connection
3.1 Usage Precautions
1) Speakers must be connected before powering the amp on.
2) All devices should be connected before powering the amp on.
3) Use straight-thru Cat5e/Cat6 with TIA/EIA T568B terminations to connect TCP/IP port.
3.2 System Diagram
IR Remote
IR Receiver
Speaker
Laptop
IR Signal:
AUDIO Signal:
Control Signal:
DVD
Figure 3- 1 System Diagram
3.3 Connection Procedure
Step1. Connect audio sources to the INPUT ports of the device with quality audio cables.
Step2. Set the Output Switch to the desired mode and connect the speakers to audio output
port (Specified in 3.4 Audio Output Connection).
Step3. (optional) Insert an IR receiver (5V, without carrier) to IR IN to enable IR control.
Step4. (optional) Connect a control device (e.g. a PC) to RS232 port to enable serial control.
Step5. (optional) Connect a control device (e.g. a PC) to TCP/IP port to enable IP control.
Step6. Plug DC 33V power adaptor to the power port of TL-A8O-50W.
4
www.tlnetworx.com
Advertisement
Table of Contents
