Table of Contents
Advertisement
2.2 Rear Panel
L
No.
Name
① CONTROL
② INPUTS
③ OUTPUTS
④ DC 33V
⑤ GND
&
Set the Output Switch to the proper speaker configuration prior to applying power to the
device.
Tx
Rx
TCP/IP
RS232
1
2
R
AUDIO
OPTICAL
Figure 2- 2 Rear Panel
Description
TCP/IP : connect with control device to enable IP control via web-
based GUI & TCP/IP communication software.
Indicators will blink when connected to control device and
communicating normally.
RS232 : 3-pole captive screw connector for serial control, it can be
connected with PC (Use a 3-pole captive to 9 pin female D
connector and serial control software) to control TL-A8O-50W
IR IN : To connect with the IR receiver, works with the IR remote.
Output Switch : Set to STEREO or MONO to enable corresponding
output mode
Audio inputs area, 3 audio inputs in total, including 1 stereo audio,
1 analog audio and 1 optical audio
LOOP : analog audio loop output port, available only when input
signal is analog stereo audio
Audio Output : including stereo audio (2x50W@8Ω), or mono
output (1x100W@4Ω)
To connect the power adapter (DC 33V 4A)
Connect to ground
1x100W
@
4
MONO
2x50W
@
8
STEREO
IR IN
3
LOOP
TL-A8O-50W User Manual
Ω
DC 33V
3
www.tlnetworx.com
Advertisement
Table of Contents
