Panasonic LUMIX DC-GX9K Basic Operating Instructions Manual page 80

Others
No flash emitted.
• The flash becomes unavailable in the following cases.
– The flash is closed.
– Flash set to [
• Set [Shutter Type] to [AUTO] or [MSHTR]. (→54)
• Set [Silent Mode] to [OFF]. (→54)
The monitor/viewfinder is turned off although the camera is turned on.
• When a hand or an object is close to the eye sensor, the monitor display mode could be
switched to viewfinder display mode. (→21)
Cannot view pictures. There are no recorded pictures.
• A card is not inserted in the camera.
• Has the file name of the picture been changed on a computer? If so, it cannot be played back
on the camera.
→ It is recommended to use the "PHOTOfunSTUDIO" software (→73) to write pictures from
PC to card.
• Set [Playback Mode] to [Normal Play]. (→56)
A Wi-Fi connection cannot be established. Radio waves get disconnected.
Wireless access point is not displayed.
General tips for using a Wi-Fi connection
• Use within the communication range of the wireless LAN network.
• If any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency
are used nearby this unit simultaneously, radio waves may get interrupted.
→ Use them sufficiently away from the device.
• When the battery indicator is flashing red, the connection with other equipment may not
start or the connection may be disrupted. (A message such as [Communication error] is
displayed.)
• When this unit is placed on a metal table or shelf, the connection may not be established
easily because the camera is affected by radio waves. Use the camera away from metal
surfaces.
About a wireless access point
• Check if the wireless access point to connect is in operating state.
• Check the radio wave condition of the wireless access point.
→ Perform the connection closer to the wireless access point.
→ Move the location or change the angle of the wireless access point.
• It may not display even if the radio waves exist depending on the setting of the wireless
access point.
→ Turn off the wireless access point and then turn it back on.
• Is the network SSID of the wireless access point set not to broadcast?
→ It may not be detected when it is set not to broadcast. Enter and set the network SSID.
Alternatively, set the network SSID of the wireless access point to broadcast.
80
DVQX1394 (ENG)
] (Forced Flash Off).