Table of Contents
Advertisement
Installation
4. Connect the water supply hose.
.
Water faucet
Water supply hose
CAUTION
● Do not make wrong
connection for the HOT
and COLD water supply
faucets.
● Tighten the nut fi rmly.
● Do not twist, squash, modify
or cut the hose.
NOTE
● If you have an uncontrolled water
heating source (e.g., wet back,
solar heating), fi t a tempering
device (e.g., a safe valve).
This will ensure the hot water
temperature remains within safe
limits. Contact a local plumber or
plumbing supply merchant for the
most suitable type of tempering
device.
● Time for hot water to reach
washing machine will depend on
proximity of washing machine to
hot water tank.
5. Connect the power plug and grounding wire.
● Plug the power cord into a dedicated household 3-pin AC outlet rated at 10 A, 220 V to 240 V.
If you are not sure, contact a qualifi ed electrician.
6. Check that the washing machine is level.
The bubble should be at
the centre of the mark.
Mark
Bubble
Leveller
7. Perform a trial operation.
● Check that there is no water leakage, abnormal sounds or error display.
14
(continued)
1
Attach one end of the water
supply hose to the water
supply valve screw.
1 Hold the elbow and tighten the nut.
2 Check that the elbow is not loose.
The procedure for cold water
●
and hot water is the same.
2
Attach the other end of the
water supply hose (grey) to
the cold water tap, and tighten
the nut clockwise with your
hand.
3
Likewise, attach the other
end of the water supply
hose (white) to the hot
water tap.
4
Turn on the water taps
slowly and make sure there
are no leaks.
■
If the bubble is out of the mark
2
Turn the adjustable
leg to eliminate
wobble.
Nut
Elbow
1
Turn the adjustable leg knob to
the left to loosen.
3
Turn to the right to
tighten.
To raise
To lower
Water supply
valve screw
COLD HOT
Water supply
hose
Hide quick links:
Advertisement
Table of Contents
