Philips HTS3548W/55 Service Manual page 13

Dismantling of the Control Board
1) Loosen 12 screws "E" on the top of control board as shown
in gure 6
E
Dismantling of the Power Board
1) Loosen 5 screws "D" at the top of the Power Board as
shown in gure 7
D
Figure 7
3 - 2
Figure 6
Dismantling of the DVD Module
1) Loosen 4 screws "F" to remove the DVD Module as shown in
gure 8.
F
Figure 8
DISASSEMBLY INSTRUCTIONS (part two--wireless)
Dismantling of the Receiver module outer cover Assembly
1) Loosen 4 screws "A "on the bottom and remove the front & top Cover by lifting the panel upwards before sliding it from the set as
shown in gure 1
4) Loosen 6 screws to remove the side & back & bottom panel
- 3 screws "B"on the bottom as shown in gure 2
- 2 screws "C" as shown in gure 3
- 1 screw "D" as shown in gure 4
A
Figure 1
C
Figure 3
Dismantling of LED Board Assembly
1) Loosen two screws "E" to remove LED Board as shown in
gure 5
E
Figure 5
3 - 2
B
Figure 2
D
Figure 4
Dismantling of the Heat Sink Board Assembly
1) Loosen two screws "F" to remove Heat Sink Board as
shown in gure 6
F
Figure 6