Kodak 24HDX100S User Manual page 28

TROUBLESHOOTING
NO PICTURE, NO SOUND
- Check if the fuse or circuit breaker is working.
- Plug another electrical device into the outlet
to make sure it is working or turned on.
- Power plug is having a bad contact with the
outlet.
- Check the signal source.
NO COLOR
- Change the color system.
- Adjust the saturation.
- Try another channel. Black-white program
may be received.
REMOTE CONTROL DOES NOT WORK
- Change the batteries.
- Batteries are not installed correctly.
NO PICTURE, NORMAL SOUND
- Adjust the brightness & contrast.
- Broadcasting failure.
NORMAL PICTURE, NO SOUND
- Press the volume up button to increase
volume.
- Volume is set to mute, press MUTE to restore
Audio.
- Change the sound system.
- Broadcasting failure.
UNORDERLY RIPPLES ON THE PICTURE
- It is usually caused by local interference,such
as cars, daylight lamps & hair driers. Adjust the
antenna to minimize the interference.
BLANK SCREEN IN PC MODE
- Perhaps the TV can not recognize the resol-
ution set by he PC. Suggest to change the best
resolution of Windows system. Set refresh rate.
SNOWY DOTS & INTERFERENCE
- If the antenna is located in a fringe area of a
television signal where the signal is weak, the
picture may be marred by dots. When the
signal is extremely weak, it may be necessary
to install a special antenna to improve the
reception.
- Adjust the position & orientation of the indoor/
outdoor antenna.
- Check the connection of antenna.
- Fine tune the channel.
- Try another channel. Broadcasting failure.
IGNITION
- Black spots or horizontal streaks appear or
the picture flutters or drifts. This is usually
caused by interference from car ignition
system, neon lamps, electric drills, or other
electrical appliance.
GHOST
- Ghosts are caused by the television signal
following two paths. One is the direct path,
the other is reflected from tall buildings, hills
or other objects. Changing the direction or
position of the antenna. This will improve
reception.
RADIO FREQUENCY INTERFERENCE
- This interference produces moving ripples or
diagonal streaks, & in some case, loss of cont-
rast in the picture. Find out & remove the radio
interference source.
26