To Turn Off Gas To Heater - Raypak WH 0135A Installation & Operating Instructions Manual

Raypak water heater user manual

Hide thumbs

Table Of Contents

Table of Contents

of the control system and any gas control which

has been under water.

For Intermittent Ignition (IID) with

Honeywell or Robertshaw Gas

Valve

1. STOP! Read the safety information above on this

label.

2. Set the tankstat on the lowest setting.

3. Turn off all electric power to the appliance.

4. This appliance is equipped with an ignition device

which automatically lights the pilot. Do not try to

light the pilot by hand.

GAS CONTROL

KNOB SHOWN

IN "ON"

POSITION

GAS INLET

HONEYWELL

(Model 0090)

Fig. 12: Honeywell Gas Valve

5. Remove heater door panel.

6. For Robertshaw Gas Valve: Turn gas control knob

clockwise

to "OFF". For Honeywell Gas

Valve: Turn gas control knob clockwise

"OFF". Make sure knob rest against stop. For

Honeywell Gas Valve: Push in gas control knob

slightly and turn clockwise to "OFF". Knob cannot

be turned to "OFF" unless knob is pushed in slight-

ly. Do not force.

7. Wait five (5) minutes to clear out any gas. Then

smell for gas, including near the floor. If you smell

gas, STOP! Follow "b" in the safety information

previously stated. If you do not smell gas, go to the

next step.

8. For Honeywell Gas Valve: Turn gas control knob

counter-clockwise

For Robertshaw Gas Valve: Move gas control

lever to "ON" position.

to "ON".

GAS CONTROL

KNOB SHOWN

IN "OFF"

POSITION

GAS INLET

Fig. 13: Honeywell Gas Valve

9. Replace door panel.

10. Turn on all electric power to the appliance.

11. Set tankstat to desired setting.

12. If the heater will not operate, follow the instructions

"To Turn Off Gas To Appliance" and call your serv-

ice technician or gas supplier.