Cleaning And Maintenance - Tesco CSVC15 User Manual

Using the Cleaner as a Handheld Device
1. Make sure the cleaner power switch is OFF. Unplug
and coil the DC supply cable and store the power
supply. Lift the cleaner off the support bracket and
place the cleaner on the floor.
Removing and Replacing the Hand Vac
2. To remove: Support the cleaner. Hold the Handle of
the Hand Vacuum, press the HAND VAC button and
release the Hand Cleaner from the Frame.
3. To replace: Place the Hand Vac into the slot in the
frame. Push it back until it clicks into place. Pull it
slightly to ensure it is locked.
Operation
4. There is an extension tube in the nozzle of the
cleaner. This has two positions - short and extended.
Pull the tube out to select the desired length. En-
sure the tube is locked in position. There is a brush
at the side of the cleaner. If you wish to use the
brush, lift it off and slide it over the extension tube.
5. Hold the cleaner securely in one hand and press the
ON OFF switch to start the cleaner.
Gently pass the cleaner over the surface. Switch the
cleaner off between operations to conserve battery life.
There is no TURBO mode when the cleaner is handheld.
After Use: Switch off both the power switches.
Replace the extension tube and brush, empty the dust,
clean the filters if necessary.
Replace the cleaner in the main frame and attach the as-
sembled cleaner to the storage bracket after use.

Cleaning and Maintenance

Removing the Dust
1. When the Dust reaches the FULL mark you must empty the Dust Cup.
2. Remove the Hand Vac from the cradle. Hold it over a bin, press the
Release Button and shake all the dust into the bin. Now close the
Dust Cup.
Cleaning the Filters and Motor Cavity
As dust accumulates in the filter, the increased resistance will cause the air
flow to decrease. Clean the filters regularly and ideally after every use.
3. Press the Dust Cup release button and remove the Dust cup from the
cleaner body.
4. Invert the cup and remove the black sponge filter.
The main filter is a two-part assembly
5. Pull the inner EPU filter out.
6. Now remove the outer mesh filter
7. Brush out the filters with a soft brush. If they are soiled, wash them
out fully under running water. Let them dry before replacing them.
Never replace a damp filter in the cleaner.
8. Brush out any debris from the motor cavity.
5
2 3
1
6
7
Page 6
CSVC15 User Guide
4
5
2
3 4
8