Copling Of The Panels Of The Built-In Column Of The Appliance Doors; Precautions For Correct Operation; Suspending Use Of The Appliance - Baumatic 34900409 Maintenance And User Manual

COUPLING OF THE PANELS OF THE
BUILT-IN COLUMN OF THE APPLIANCE
DOORS
The appliance is equipped with coupling devices for the appliance
doors with the column panels (loader slide).
Secure the slide in the inner part of the panel of the built-in column at the
desired height and at approx. 20 mm. From the outer edge of the door.
Open the doors of the built-in column and the fridge. Position the built-in
loader in the slide, then fit it into the fridge door.
Mark the fixing points for the screws and drill with a bit of a
diameter of 2.5mm.
Connect the appliance door to the cabinet panel keeping the
loader slots as guidelines.

PRECAUTIONS FOR CORRECT OPERATION

Once the product has been embedded, place the rear part of
the column in contact with the wall so as to prevent access to the
compressor compartment.
For the product to operate correctly it is essential to allow adequate air
circulation so as to cool down the condenser located in the rear part
of the appliance.
For this reason, the column must be equipped with a rear chimney,
whose upper opening must not be blocked and with a front slot which
will be covered with a ventilation grill.

SUSPENDING USE OF THE APPLIANCE

If the appliance is not to be used for a long time:
1) Turn the appliance OFF (see Operation).
2) Extract the plug or remove the safety device.
3) Clean the appliance
4) Leave the doors of the appliance open.
EN 9