Tsc; Optional Remotes - Heart Interface 10 Owner's Manual

• When the LED is blinking slowly (1 time
per second), an over current condition or a
short circuit has occured. The system has
shut OFF and will not automatically restart.
Correct the fault condition and manually restart
the system.
LOW BATTER LOW BA LOW BA LOW BA LOW BA TTER TTER TTER TTERY Y Y Y Y & OVERTEMP/OVERLOAD & OVERTEMP/OVERLOAD & OVERTEMP/OVERLOAD & OVERTEMP/OVERLOAD & OVERTEMP/OVERLOAD
- Red LEDs
• When both LEDs are blinking, an AC
backfeed has been detected. A backfeed
occurs when AC power from an external
source is connected to the output of the
i n v e r t e r. Inspect wiring for possible input/output
w i r i n g e r r o r. This condition will damage the unit
and must be corrected before further
operation.
TSC (T TSC (T emperature Sensitive Charging) emperature Sensitive Charging)
TSC (T TSC (Temperature Sensitive Charging) TSC (T emperature Sensitive Charging) emperature Sensitive Charging)
This provides for the connection of a
sensor to measure battery temperature for
compensated charging. If no sensor is
connected the charge voltage levels are set to
defaults based on battery type.

OPTIONAL REMOTES

OPTIONAL REMOTES OPTIONAL REMOTES OPTIONAL REMOTES OPTIONAL REMOTES
If using one of the remotes, refer to the
installation instructions included with the
remote.
Note: When a Remote Control Panel or
Link is installed, the jumper included in the
p a r t s p l a s t i c b a g i s not not not not used in the Auxiliary not
Switch Port (AUX SWITCH) on the front panel
of the inverter/charger. See page 23 for more
d e t a i l s .
Part No. 90-0123-00
Libertycombi.p65 11/05/99
O P E R A O P E R A
O P E R A TION
O P E R A O P E R A
Overtemp Overtemp Overtemp Overtemp Overtemp
L o w L o w L o w L o w L o w

TSC

TSC TSC TSC TSC
Remote Remote Remote Remote Remote
Battery Battery Battery Battery Battery
TION TION
TION
TION
Auxiliary Port Auxiliary Port Auxiliary Port
Auxiliary Port Auxiliary Port
9