Tripp Lite SNMPWEBCARD Installation Instructions Manual page 18

Installation
SNMPv3 Definitions
User Name
Authentication Passphrase
Privacy Passphrase
Authentication Protocol
Privacy Protocol
Attach Faceplate: Using one hand to hold the card in place, temporarily
4-3
detach the network cable. Align and attach the faceplate that matches
your UPS system, using screws from the accessory slot cover. Reattach
the network cable.
201203126 933179.indb 18
The identifier of the user profile. SNMP version
3 maps Gets, Sets and Traps to a user profile
by matching the user name of the profile to the
user name in the data packet being transmitted.
A user name can have up to 32 ASCII characters.
A phrase of 8 to 32 ASCII characters that verifies that the
Network Management System (NMS) communicating
with this device through SNMPv3 is the NMS it claims
to be, that the message has not been changed
during transmission, and that the message was
communicated in a timely manner, indicating that it was
not delayed and that it was not copied and sent again
later at an inappropriate time. Note: The authentication
passphrase maps to a user's SNMPv3 password.
A phrase of 8 to 32 ASCII characters that ensures the
privacy of the data (by means of encryption) that a
Network Management System (NMS) is sending to this
device or receiving from this device through SNMPv3.
Note: The privacy passphrase maps to a user's password.
The Tripp Lite implementation of SNMPv3
supports only MD5 authentication.
The Tripp Lite implementation of SNMPv3
supports only DES as the protocol for encrypting
and decrypting data.
18
4/5/2012 5:11:08 PM