Roper RT18DK Use And Care Manual page 11

Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation.
The longer you store cubes, the smaller they
get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Using the optional automatic ice maker
If your refrigerator has an automatic ice
maker, or if you plan to add one later (Kit
No. FRKIT94), here are a few things you will
want to know.
l
The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically
UP to shut off the ice maker
IMPORTANT: Do not turn on the ice
maker until it is connected to the water
supply. Instructions for ice maker water
supply hookup are attached to the back
of the refrigerator cabinet.
l
The dial or lever on the side of the ice
maker changes the size of the cubes.
l
You may hear water running when the ice
maker is working. You'll hear ice falling
into the bin. Don't let these sounds bother
you.
l
If you remove the ice bin, raise the signal
arm to shut off the ice maker. When you
replace the bin, push it in all the way and
lower the ice maker signal arm to the ON
position.
l
Good water quality is important for good
ice quality. Try to avoid connecting the ice
maker to a softened water supply. Water
softener chemicals (such as salt from a
malfunctioning softener) can damage the
ice maker mold and lead to poor ice
quality. If a softened water supply cannot
be avoided, make sure the water softener
is operating properly and well maintained.
11