Troubleshooting - AcuRite 00484 Instruction Manual

Troubleshooting

Problem
No outdoor sensor
reception
no bars
Display screen
not working
Outdoor
temperature
is flashing or
showing dashes
Inaccurate forecast
Inaccurate
temperature
or humidity
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.
If the wireless signal indicator shows no bars:
• Relocate the display and/or the outdoor sensor.
The units must be within 165 ft (50 m) of each other.
• Make sure both units are placed at least 3 feet
(.9 m) away from electronics that may interfere with
the wireless communication (such as TVs, microwaves,
computers, etc).
• Use standard alkaline batteries (or lithium batteries in
sensor when temperature is below -4ºF/-20ºC). Do not
use heavy duty or rechargeable batteries. NOTE: It may
take a few minutes for display and sensor to synchronize
after batteries are replaced.
• Check that the power adapter is plugged into the display
and an electrical outlet.
Flashing of the outdoor temperature is generally an
indication of wireless interference.
1. Bring both the sensor and display indoors, side by side
and remove power adapter/batteries from each.
2. Reinstall batteries in the outdoor sensor.
3. Reinstall power adapter/batteries in display.
4. Let the units sit within a couple feet of each other
for a few minutes to gain a strong connection.
• Weather Forecast icon predicts conditions for the next
12 to 24 hours, not current conditions.
• Has Learning Mode icon disappeared from the display?
Learning Mode must complete before forecast and
pressure will be accurate.
• Allow unit to run continuously for 33 days. Battery
removal or resetting the display will restart Learning
Mode. After 14 days, forecast should be fairly accurate,
however Learning Mode calibrates for a total of 33 days.
• Make sure both the display and sensor are placed out of
direct sunlight and away from any heat sources or vents
(see page 8).
• Make sure the display is positioned away from moisture
sources (see page 8).
11
Possible Solution