Honeywell HCM-750 Series Safety Instructions page 5

CLEANING YOUR HUMIDIFIER (continued)
Disinfecting directions: Disinfect following scale removal
STEP 1
STEP 2
DO NOT DISINFECT the Set aside top grille,
wicking filters. protective clear cover,
filter tray, water pump,
water hose, water fill
baffle and fill funnel.
STEP 4 STEP 5
Soak water hose, water Soak for 15-20 minutes.
pump, water fill baffle,
Wipe top grille and filter tray
fill funnel and protective
with the bleach solution if
clear cover in water
these parts were not placed
reservoir of the main
in dishwasher. Thoroughly
housing if these parts
rinse main housing and
were not cleaned on the
any parts not placed in
top rack of dishwasher.
dishwasher until the smell
of bleach is gone.
Note: Please be careful of clothing, rugs and other non bleach resistant materials when
disinfecting. Spilling bleach on clothing, rugs and certain surfaces may cause damage.
8
STEP 3
NOTE: USING MORE
THAN 1 TSP OF
BLEACH PER GALLON
OF WATER MAY RESULT
IN DAMAGE TO YOUR
HUMIDIFIER.
Add 1 teaspoon of bleach
to 1 gallon water. Add the
bleach solution to water
reservoir of the main
housing. Using this
mixture, wipe the walls
of the main housing.
REASSEMBLING YOUR HUMIDIFIER
STEP 1
Reassemble pump by Do Not Re-Assemble
inserting impeller disk Pump with impeller disk
with blades facing front blades facing towards
housing onto front hous- back cover. Incorrect
ing shaft. Replace back assembly will not allow
cover and turn clock- you to attach rear cover.
wise to lock in place.
STEP 4 STEP 5
Line up the fill funnel
Affix water hose to
with the slots behind the
main housing by gently
water window. Gently
inserting water hose
insert into place.
onto the water outlet.
STEP 8
Replace the top grille and
protective clear cover.
END-OF-SEASON CARE AND STORAGE
Follow the CLEANING instructions when the humidifier will not be used for at least one week or more, or
at the end of the season.
NOTE: Discard old filters and start with new filters next season.
Dry the humidifier completely before storing.
DO NOT store with water inside the main housing water reservoir or water tube.
Pack unit in original carton and store in a cool, dry location.
STEP 3
STEP 2
Insert pump outlet Insert water pump/hose
into hose opening and assembly into slot
gently press into place in main housing.
until water pump outlet Note: The pump will
will not sit any further only fit one way.
inside water tube.
STEP 7
STEP 6
Re-insert the water fill Place filter tray onto
baffle into the water main housing. Then
reservoir of the main replace the filters back
housing by lining up onto the filter tray.
with the guides and
gently pushing down
to insert.
9