Advertisement
Quick Links
INSTALLATION CERTIFICATE
The undersigned qualified installer attests to have personally fitted the here described system following the
manufacturer instructions.
By :
Sold on :
.................................................................
Vehicle :
..........................................................................................................................
GEMINI Technologies S.p.A.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia
Tel. +39 0332 943211 - Fax +39 0332 948080
Web site: www.gemini-alarm.com
Type of product :
818H
Reg. n.532-A
UNI EN ISO 9001:2008
KIT Parking
Sensor 818H
INSTALLATION AND
USE MANUAL
UK
AC 2878/UK Rev. 00 - 02/12
Advertisement
Related Manuals for Gemini 818H
Summary of Contents for Gemini 818H
- Page 1 INSTALLATION CERTIFICATE The undersigned qualified installer attests to have personally fitted the here described system following the manufacturer instructions. KIT Parking By : Sensor 818H Type of product : 818H Sold on : INSTALLATION AND ..............USE MANUAL Vehicle : ..........................
- Page 2 Sensor 1: front with shortest cable. Sensor 4: front with longest cable. BROWN BLACK BLUE BLACK-BLUE BROWN BLACK-YELLOW km/h GREY-RED MAIN UNIT MUTE BROWN BROWN BLACK-BLUE REAR UNIT Sensor 5: rear with BLACK shortest cable. Sensor 8: rear with longest cable. BLUE TECHNICAL SPECIFICATIONS Supply voltage...
-
Page 3: Table Of Contents
USER MANUAL CONTENTS - PRELIMINARY ADVICE..................... PAGE 02 3.0 - SYSTEM OPERATION USER MANUAL Remember to always look around the vehicle while parking. - DYSTEM OPERATION....................PAGE 03 Small obstacles or objects with low reflectance might not be detected. 2.1 - Detection Zones...................... PAGE 03 2.2 - Rear sensors...................... -
Page 4: Rear Sensors
The warranty is valid exclusively at authorized Gemini Technologies centers. If, within the preset time, no obstacle is detected in front of the vehicle, the sensors will The manufacturer declines any responsability for eventual malfunctions of the parking sensors or any automatically be deactivated. -
Page 5: Installation Of Sensors
INSTALLER MANUAL 6.0 - INSTALLATION OF SENSORS To install the sensors on a metal bumper, you must use appropriate adapters (not supplied). Choose the suitable type of plastic br acket and mark the center of the holes to drill. For brackets “9” drill holes with a 18mm diameter, for brackets “9a” drill holes with a 22mm diameter and for brackets “10”... -
Page 6: Connections
Snap the bracket (11 or 12) in the hole from the outer part of the bumper. 7.0 - CONNECTIONS osition the plastic brackets so that the connector of the sensor comes out horizontally 11 12 MUTE +12V DATA Check the length of the cables before proceeding with the final positioning of the accessories. -
Page 7: Programming
8.0 - PROGRAMMING 9.0 - SETTING OF PARAMETERS 9.1 - FRONT UNIT (MAIN UNIT) Only expert users should modify these settings to avoid malfunctions of the parking system. PARAMETERS RANGE SETTING Volume of buzzer 0, 1, 2 ( Ref.1 The unit display (front and rear) will show one of the following indications: Detection range of front central sensors From 50 to 95 cm Detection range of front corner sensors...