Replacing Carbon Brushes - Dolmar EC-1235 Instruction Manual

Replacing carbon brushes

1
001146
When the resin insulating tip inside the carbon brush is
exposed to contact the commutator, it will automatically
shut off the motor. When this occurs, both carbon
brushes should be replaced. Keep the carbon brushes
clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only
identical carbon brushes.
Pick up an end of the dust cover slightly with hands so
that brush holder cap appears.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
004020
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Dolmar Authorized or Factory Service
Centers, always using Dolmar replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Dolmar tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar service center.
Abrasive cut-off wheels
•
14" diamond wheels
•
Socket wrench 17
•
Safety goggle
•
Ring 20
•
1. Commutator
2. Insulating tip
2
3. Carbon brush
3
1. Dust cover
2
2. Screwdriver
3. Brush holder
3
cap
or attachments
Only use accessory or
Elbow joint
•
Connecting to vacuum cleaner
3
004379
When you wish to perform cleaner operation, connect a
vacuum cleaner to your tool. Connect a hose of vacuum
cleaner to the dust nozzle via an elbow joint (accessory).
are
6
2
1. Dust nozzle
2. Elbow joint
3. Hose
1