Functional Description - Dolmar EC-1235 Instruction Manual

grinder frequently kick and cause loss of
control leading to personal injury.
9. Hold the tool firmly.
10. Keep hands away from rotating parts.
11. Make sure cord is clear of wheel. Do not wrap
cord around your arm or wrist. If control of
tool is lost, cord may become wrapped around
you and cause personal injury.
12. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
13. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced wheel.
14. Watch out for flying sparks. Hold the tool so
that sparks fly away from you and other
persons or flammable materials.
15. Do not leave the tool running. Operate the tool
only when hand-held.
16. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
17. ALWAYS wear proper apparel including long
sleeve shirts, leather gloves and shop aprons
to protect skin from contact with hot cuttings.
18. Use of this tool to cut some products could
expose user to dust containing hazardous
substances. Use
protection.
19. The tool must be used only for dry cutting. DO
NOT use water.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
alternating or direct current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
appropriate respiratory
USD291-2

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of cut
1
3
004377
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
Only case you adjust the cutting depth to the maximum
one, always be sure to do the adjustment after
adjustment of the wheel guard.
Securing wheel guard
2
004014
CAUTION:
The wheel guard must be adjusted on the tool so
•
that the closed side of the guard always points
toward the operator.
The wheel guard can be adjusted about 80 degrees,
after you loosen the clamping nut. Adjust to the desired
angle, then secure the clamping nut.
Switch action
A
1
B
2
004015
4
1. Wing bolt
2. Base
3. Cutting depth
2
1. Clamping nut
1
2. Wheel guard
1. Switch trigger
2. Lock lever