Page 1
I N S T A L L A T I O N I N S T R U C T I O N S Instrucciones de instalación Istruzioni di installazione Installationsanleitung Installatie-instructies Instruções de Instalação Instructions d´installation Outdoor Articulating Wall Mount Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description SB-WM46...
Installation Instructions SB-WM46 DIMENSIONS 16.00 406.4 MAX EXTENSION 21.66 550.2 1.00 MAX TILT 25.4 15° 0.38 PADLOCK MAY BE ADDED FOR SECURITY 1/4" OR 5/16" DIAMETER SHANK...
Page 4
SB-WM46 Installation Instructions LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación...
5/8" thick drywall, plywood, OSB, fiberboard, buffalo board or other similar sheathing materials. IMPORTANT ! : The SB-WM46 mounts may be installed to a (Y) x 4 bare 8" concrete wall if 5/16 x 3" Buildex® Tapcon® anchors with Blue Climaseal®...
Page 7
Installation Instructions SB-WM46 Installing Interface Brackets to Display Place display face down on a soft, non-abrasive surface. (AA-AK) x 4 (If applicable) Remove four sets of bolts and washers that were shipped attached to the back of the display. (See...
Page 8
SB-WM46 Installation Instructions Using 5/32” hex key (H), install four 1/4 x 5/8” button head Install Faceplate to Display cap screws (K) through four 1/4” washers (L), faceplate (Z), Align faceplate brackets (B or C) with interface brackets (D faceplate brackets (B or C), into four 1/4” nuts (M). Tighten or E), aligning the center of display with the faceplate bolt.
(W) or screws (R). all components located between the SB-WM46 up to (and Carefully insert cables into cavities located in lower portions including) the display does not exceed 150 lbs (68 kg).
Page 10
SB-WM46 Installation Instructions Adjustments Extension and Swivel Tension Pitch WARNING: Excessive loosening or tightening of Loosen pitch adjustment knob. (See Figure 15) adjustment screws can result in serious personal injury or Tilt display to desired angle (-15° to +15°). (See Figure 15) damage to equipment! Tighten pitch adjustment knob.
Page 11
Installation Instructions SB-WM46 Locking in Collapsed Position The SB-WM46 may be locked in the collapsed position by using the locking pin (V). Insert locking pin (V) through lower bracket on main assembly (A) and into holes on brackets behind faceplate.
Need help?
Do you have a question about the SB-WM46 and is the answer not in the manual?
Questions and answers