GeoBox G-403 User Manual

G-403 User Manual
------------------------------------------------------------------------------------------------------------------------------------------------
For Preset display mode user
1. Check User Manual (UM) to select the display mode # as you need. Please also pay attention to the Bezel
Correction setting.
2. Set Display Mode dip SW based on the modes #. If the No. is 125, it means the dip SW pin 1, 2 & 5 should be
set at ON (up) position. All the rest is still at OFF (down) position.
3. Install the LCD display as showed in UM with correct position, angle and direction.
4. Disable 'OVERSCAN" function if you use conventional TV. Otherwise the image location may be shifted.
5. Disable 'Matrix" control function in the LCD. Otherwise, the image location will be shifted.
6. Select input port and set EDID in G-403 ([Options] [Setting] [EDID])..
7. Power on signal source, G-403 and LCD, then you will see the result.
8. User can set the time for automatically turn off output signals if no input signal is detected.
9. If there is image shift, please check if you select the right mode for bezel compensation.
10. If you want to add PIP or display two contents on the video wall, please enable PIP/POP mode.
11. If any change is required in Dip SW, please turn system OFF & ON again to get new setting.
12. Please check output LED indicators and make sure all output LED is ON. It means GeoBox had handshake
with display devices already.
13. You can connect a monitor via loop out port to see original signal for easy system operation.
14. Please note that poor cable or long distance connection may cause dot noise
G-403 Advanced applications through remote controller and OSD
1. User can use more advanced functions by OSD menu through remote controller.
2. If GeoBox is installed at a location that can't be directly accessed by remote controller, please connect IR
Extender to IR Ext connector on the back panel and set IR receiver at a position that can be accessed.
3. Turn all Dip SW pins in [Main Input] to OFF position to switch the authority of the system control to OSD
setting. If any [Main Input] Dip SW is turned to ON position, Dip SW setting command will be the 1
execute if OSD setting is conflicted with Dip SW setting.
4. Apply input signal and select input port by OSD and remote controller.
5. User can set the time for automatically turn off output signals if no input signal is detected. Once the input
signal appears again, the system will power on automatically. It is convenient for system power management.
6. User can open OSD and access to [Video Wall] [Output Mode] menu to select Preset display mode. The
result is the same as manual DIP SW selection. User can't fine-tune image position.
7. More flexible PIP/POP settings can be implemented from OSD menu.
8. User can create his own display mode with LCD at any angle and position by OSD [Manual Mode] or GAlign
PC Tool. User can fine-tune image position in Manual mode settings.
9. If necessary, user can connect a monitor via loop out port to see original signal for easy system operation.
10. New RC-700 remote controller allows user to access all [Manual Mode] operation without seeing OSD menu.
User can select [Index]
G-403 Quick User Guide
[TV#] [Top Left] or [Top Right] corner to input coordinate directly and set image
1
Document: G-40302
or unstable signal.
st
priority to