Securing The Pedestal To The Mounting Platform - Raymarine Radar Scanner Owner's Handbook Manual

28

Securing the pedestal to the mounting platform

1. Using the paper template supplied with the scanner mounting kit,
mark the flat mounting surface with the holes and drill as indi-
cated on the template. Refer to Section 1.2 when selecting the
scanner unit site.
2. Stick the four self-adhesive bitumen washers over the mounting
holes.
3. Ensure the lifting eyes are securely fitted to the top of the pedestal,
and the yellow protective cap is in place.
CAUTION:
To prevent damage to the internal mounting bar, ensure the stud
penetration is no more than 32 mm into the pedestal base. We
recommend you mark each stud with tape, 32 mm from one end,
to act as a gauge.
4. Grease the studs. Using two nuts locked together on the stud,
screw each stud into the pedestal to a maximum of 32 mm, or
until they bottom out. Remove these two nuts.
Note: If the studding supplied is not long enough, use M10 stainless
steel, grade A4 studding of a suitable length. Refer to the following il-
lustration for details.
5. Using suitable lifting equipment, raise the pedestal over the
mounting surface. Carefully lower into position, taking care that
the studs pass through the holes without damaging the threads.
Ensure that the cable inlet is pointing aft.
WARNING:
Support the pedestal unit until it has been secured to the
mounting platform. It is important that all four sets of nuts and
washers are used to secure the pedestal to the mounting platform.
6. Referring to the following illustration, use the four nuts and asso-
ciated washers supplied to secure the pedestal. Tighten the nuts to
20 Nm (14.7 lb ft); ensure the scanner is tightly fitted.
Grease the nuts.
If required, cut-off any excess stud.
Pathfinder Radar Scanners