Advertisement
- 14 -
- 3 -
12. Producer
4. Preparing the instrument
TANEL Electronics
PL, 44-100 Gliwice, ul. Kopernika 121
a) Preparing the instrument without the change in settings
tel./fax +48 32 234-96-15; 238-16-15
http://www.tanel.com.pl/
In this case quickly switch the upper control to
SETTINGS CHECK. The LCD will display the density and
thickness set during the previous measurements (e.g. 0.56
and 42). Hold the device in the air (fig. 1), switch the upper
control knob to MEASURE. The device will calibrate
automatically (the display shows - - -). The end of
calibration is indicated by the number 4.0 (the lower range
limit) displayed on the LCD. The device is ready for
measurements.
Fig. 1
Advertisement
