Elektrotechnik Schabus SHT 5000 Operating Instructions Manual page 12

6.4 Settings of the miniature switch
At the delivered condition of the product, the miniature switch
is set, as depicted in the picture on the right.
Switch1: ON = Battery monitoring is shut off
Switch2: ON = Storage function for Sensor 1 is switched on
Switch3: ON = Storage function for Sensor 2 is switched on
Switch4: ON = Storage function for Sensor 3 is switched on
Switch5: ON = Storage function for Sensor 4 is switched on
Switch6: ON = Buzzer is for all channels active
Switch7: ON = Buzzer for Channel 1 is active
Switch8: ON = Buzzer for Channel 2 is active
Switch9: ON = Buzzer for Channel 3 is active
Switch10: ON = Buzzer for Channel 4 is active
6.5 Relay connection configuration
When connecting additional devices to the potential-free relay, please note that the switching
capacity may not be exceeded.
► Relay status in monitoring mode:
The relay is „energized" (make contact closed/break contact open)
► Relay status in alarm mode:
The relay „decreases" (make contact open/ break contact closed)
Wiring example: Magnetic cut-off valve
L
L N PE
Operating voltage
230 V AC
50-60 Hz
12
Relay
8A/230V
L N N PE PE S G Ö
Option:
9V battery
Relay plug-in card
connection
Sensor 3
Sensor 1 Sensor 2
Float switch Float switch
Float switch
ON
1 2 3 4 5 6 7 8 9 10
Miniature switch
Buzzer
Sensor 4
Float switch
Magnetic cut-off valve
(closed in non-operating condition)