Advertisement
Unscrew the spacer on top and disconnect the two boards. Next place the four p otentiometers ( B100k)
to their respected places on the top board. Push them well until they sit absolutely flat on the board.
Then place the m ono jacks and the s witch o n the board. Don't solder anything yet .
Place the s pacer b ack in the opening. Take the f ront panel, screw a nd mount it with the board. Check
that all the components came through. Secure the jacks to the panel with the w ashers a nd the n uts
(keep in mind not to tighten the jack nuts too much as you may damage the panel!).
To ensure that the headers are properly aligned, screw the h ex
screw a nd the 1 1 mm spacer (nut nut) on bottom board. Place
the f emale headers on bottom board with the male pins
inserted . C onnect the boards together and mount them with the
other spacer ( 1 0 mm one, screw nut). Now you can s older the
headers on both boards.
5
Advertisement
