Mitsubishi EVO X Repair Manual page 25

Front floor panel front heat
protector and front floor panel
rear heat protector removal
steps (Continued)
4. Heated oxygen sensor (rear)
connector
6. Catalytic converter
Cowl side trim (Refer to GROUP
•
52A, Trims P.52A-11).
Footrest
•
Floor console side cover (Refer to
•
GROUP 52A, Front Floor
Console Assembly P.52A-9).
Turn up the passenger side floor
•
carpet.
Front floor backbone brace (Refer
•
to GROUP 42, Loose Panel
P.42A-192).
7. Heated oxygen sensor (front)
connector
9. Front exhaust pipe
10. Seal ring
14. Exhaust pipe gasket
16. Exhaust pipe gasket
19. Seal ring
Propeller shaft assembly (Refer
•
to GROUP 25, Propeller Shaft
P.25-6).
B A
<< >> >> << 20. Rivet
B A
<< >> >> <<
21. Front floor rear panel heat
protector
22. Dash panel heat protector
B A
<< >> >> <<
23. Rivet
24 Heated oxygen sensor clip
B A
<< >> >> <<
25. Front floor front panel heat
protector
Required Special Tool:
• MB991953: Oxygen Sensor Wrench
INTAKE AND EXHAUST
EXHAUST PIPE AND MAIN MUFFLER
REMOVAL SERVICE POINTS
.
<<A>> HEATED OXYGEN SENSOR REMOVAL
Use special tool MB991953 to remove the heated oxygen sen-
sor.
Heated oxygen
sensor
MB991953
AC301966 AG
.
TSB Revision
15-25